Over the past few nights I was able to get almost all the pilings and piling caps to the wharf at Aquia Landing installed.
In the photo you can see the spacer brackets I made to hold the pilings and piling caps in place while the glue dried. The stringers are not glued in yet, they are just temporarily in place.
I may enlarge the wider area of the wharf to better accommodate the paddle wheel steamer, which you an see mocked up here on the left.
I am trying to decide what the next step should be. I might pour the water next. That way if I have a problem with the resin, I can access the area under the wharf deck. In the worst case, I can scrape it off and try again. Once the deck is installed, there will be limited access underneath it. Stay tuned!